Connecting A Computer For Controlling The Projector; Connecting The Computer Via The Ethernet; Connecting The Computer Via The Rs-232C - Sony SRX-R105 Operating Instructions Manual

Connecting a Computer
for Controlling the
Projector
Connect a computer for controlling the projector to the
projector via the ETHERNET connector or the RS232C
connector.
Connecting the Computer via the
Ethernet
Connect the computer to the projector using the supplied
ethernet cable (cross cable).
Note
Set the TCP/IP protocol of the connected computer to
DHCP.
INTER LOCK ETHERNET RS232C
ETHERNET connector
Ethernet cable (cross cable)
(supplied)
Ethernet connector
16

Connecting a Computer for Controlling the Projector

R(P /C ) G(Y/Y) B(P /C ) HD VD
r r b b
R(P r /C r ) G(Y/Y) B(P b /C b ) HD VD
IN OUT
IN OUT
Computer
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
Note
If the power of the projector remains on for a long period
of time without the Ethernet cable connected, the message
"Sony SR Projector Initializing..." may appear in the
STATUS MESSAGE window while you are setting up for
networking after connecting the Ethernet cable. This is not
a malfunction of the projector.
Connecting the Computer via the
RS-232C
INTER LOCK ETHERNET
RS232C
RS232C connector
Connecting cable (not supplied)
RS-232C connector
R(P /C ) G(Y/Y) B(P /C ) HD VD
r r b b
R(P /C ) G(Y/Y) B(P /C ) HD VD
r r b b
IN OUT
IN OUT
Computer