Sony SLV-X821MK2 Instruction & Operation Manual page 24

Notes
• If you inadvertently
entered a guide channel
number, press CURSOR
>/. repeatedly to reset the
"GUIDE CH" column to
"---". "---" appears between
1 and 255.
• The VCR does not allow
entering the guide channel
number, if the same
number has been set.
• If you leave the GUIDE CH
column blank (---), the VCR
will record the signal
through LINE IN when
recording with G-CODE.
Note
• When you record a satellite
broadcast using G-CODE,
you need to select the
desired channel on the
satellite tuner manually.
6 Press CURSOR >/. to select the guide channel number assigned in
the program guide.
SET UP CH AND G–CODE
PROG CH GU I DE CH
1 3 – – – –
2 9 – – – –
3 1 2 – – – –
4 2 7 – 2 5
5 5 6 – – – –
:
SELECT
SET :
7 Press CURSOR / to confirm the setting.
I
The cursor ( ) appears in the leftmost column.
SET UP CH AND G–CODE
PROG CH GU I DE CH
1 3 – – – –
2 9 – – – –
3 1 2 – – – –
4 2 7 – 2 5
5 5 6 – – – –
:
SELECT
:
MOVE PROG 3
–
SET GUI DE CH :
8 To set the guide channel of another station, repeat steps 3 to 7.
If you want to change the program positions of the stations, proceed
to step 2 of "Changing the program positions of the stations" on
page 26.
9 When you've finished, press EXECUTE to exit.
Setting up G-CODE for satellite broadcasts
When your satellite tuner is connected via the AERIAL IN connector,
first you have to set the program position for each satellite channel
using the TUNER PRESET menu. Then set the guide channel number
for each satellite channel using the SET UP CH AND G-CODE menu.
1 Turn on the satellite tuner.
2 Press MENU, then select TUNER PRESET and press EXECUTE.
3 Press PROG +/– to select a program position you want to use for
watching a satellite channel.
4 Select CHANNEL SET, then press CURSOR / to tune the VCR to
the satellite tuner.
The channel number displayed beside CHANNEL SET is used for
receiving all satellite broadcasts from the satellite tuner.
Selected program position
TUNER PRESET PROG 6
SYSTEM I D / K B / G M
NORMAL / CATV NORM CATV
CHANNEL SET 3 0
AF T ON OFF
F I NE TUN I NG
:
SET
5 Press PROG +/– to select another program position for another
satellite channel, and press the program number buttons to enter the
same channel number as the one displayed in step 4.
Repeat this step for all satellite channels.
6 Set the guide channel number for each program position
assigned to the satellite channel, following the procedures in "Setting
the guide channels" on pages 24 and this page.
25 -EN
Getting Started