Shutting Down The Projector; Direct Power Off - BenQ MX611 User Manual

• The brightness level of the projected image will change accordingly when you switch between different input
signals.
• For best display picture results, you should select and use an input signal which outputs at the projector's native
resolution. Any other resolutions will be scaled by the projector depending upon the "aspect ratio" setting,
which may cause some image distortion or loss of picture clarity. See

Shutting down the projector

1. Press on the projector or
and a confirmation message will appear prompting you. If
you don't respond in a few seconds, the message will
disappear.
2. Press or
flashes orange, the projection lamp shuts down, and the
fans will continue to run for approximately 90 seconds to
cool down the projector.
3. Once the cooling process finishes, the power indicator
becomes a steady orange and fans stop. Disconnect the
power cord from the power outlet.
• To protect the lamp, the projector will not respond to any commands during the cooling process.
• To shorten the cooling time, you can also activate the Quick cooling function. See
• Avoid turning on the projector immediately after turning it off as excessive heat may shorten lamp life.
• Lamp life results will vary depending on environmental conditions and usage.

Direct power off

The AC power cord can be pulled out right after the projector is turned off. To protect the lamp, wait
about 10 minutes before re-starting the projector. If you attempt to re-start the projector, the fans may
run for a few minutes to cool down. In such cases, press
the fans stop and the power indicator turns orange.
on the remote control
a second time. The power indicator
Aspect Ratio on page
Quick Cooling on page
or again to start the projector after
24.
30.
Operation 23