Table of Contents
Advertisement
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[AUTO] and [LINK] is set from [GROUP A] to [GROUP D]
The screen shows the status of the brightness control of
synchronized projectors (up to eight units), including the projector
being controlled through the on-screen menu.
BRIGHTNESS CONTROL STATUS
LINK
PROJECTOR
1:
PROJECTOR2
2:
PROJECTOR3
3:
4:
5:
6:
7:
UPDATE
MENU SELECT
1
Display the name of the projector.
2
Display the synchronized group.
3
Display the IP address of the projector.
4
Display the names and IP addresses of projectors in same
group detected over the network.
5
Display the status by color.
Green: There is an allowance for brightness correction.
Yellow: There is little allowance for brightness correction.
Red: There is a brightness control error.
r Error details
Error message
[Exceed maximum number of
projectors.]
[Please check the COMMAND
CONTROL setting.]
[Please check the USER NAME
and PASSWORD in the COMMAND
CONTROL setting.]
[Cannot apply BRIGHTNESS
CONTROL. Please check projector
status.]
[Brightness Sensor Error]
*1 "Multi Projector Monitoring & Control Software" is included in the supplied CD-ROM.
Note
f If the synchronized projectors are not displayed in the list, check the following:
g Are there devices with the same IP address on the network?
g Are the LAN cables connected correctly? (x page 100)
g Are the subnets of the projectors the same?
g Are the same [LINK] settings applied to a group?
f Refer to "[NETWORK SETUP]" (x page 99) or "[Network config] page" (x page 107) on how to change the projector name.
82 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
1
GROUP A
2
3
192. 168. 30. 2
192. 168. 30. 3
192. 168. 30. 4
4
5
7
8
f Limit the number of projectors in one group to eight.
f When synchronizing nine or more projectors, use the dedicated software "Multi Projector
Monitoring & Control Software"
f Set [COMMAND CONTROL] in [NETWORK CONTROL] of the projector displaying an error to
[ON].
f Assign the same value to [COMMAND PORT] of the [NETWORK CONTROL] of all projectors to be
synchronized.
f Assign the same [User name] and [Password] strings of the web control administrator rights of all
projectors to be synchronized.
f The projector is in standby. Switch on the power.
f There is a problem with the brightness sensor. If problems persist even after switching the power
on, consult your dealer.
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[PC]
BRIGHTNESS CONTROL STATUS
MODE
PROJECTOR
RETURN
MENU
6
Display error detailed messages.
7
Display error messages.
When the message [Failed to apply BRIGHTNESS CONTROL
to some projectors.] appears, it means that synchronization with
the projector displayed in red has failed.
Press as to select the projector displayed in red, and press
the <ENTER> button to display the error details.
8
Update to the latest status information.
Measures to take
through a computer.
*1
PC
1
5
6
Advertisement
Table of Contents
