Table of Contents
Advertisement
5)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
Note
f When using a DHCP server, confirm that the DHCP server is running.
f Consult your network administrator regarding the IP address, subnet mask, and default gateway.
[NETWORK CONTROL]
Set up the control method of the network.
1)
Press as to select [NETWORK CONTROL].
2)
Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3)
Press as to select an item, and press qw to change the setting.
[WEB CONTROL]
[PJLink CONTROL]
[COMMAND CONTROL]
[COMMAND PORT]
[CRESTRON RoomView]
[AMX D.D.]
[EXTRON XTP]
[STORE]
4)
Press as to select [STORE], and press the <ENTER> button.
5)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
[NETWORK STATUS]
Display the status of the projector network.
1)
Press as to select [NETWORK STATUS].
2)
Press the <ENTER> button.
f The [NETWORK STATUS] screen is displayed.
Network connections
The projector has a network function, and the following operations are available from the computer using the web control.
f Setting and adjustment of the projector
f Display of the projector status
f Sending of E-mail messages when there is a problem with the projector
The projector supports "Crestron RoomView", and the following application software of Crestron Electronics, Inc. can be used.
f RoomView Express
f Fusion RV
f RoomView Server Edition
Attention
f Connect the LAN to indoor devices.
100 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
Set to [ON] to control with the web browser.
Set to [ON] to control with the PJLink protocol.
Set to [ON] when controlling the projector with the control command format (x page 129) of the
<SERIAL IN> terminal. Refer to "Control commands via LAN" (x page 125).
Set the port number used for command control.
Set to [ON] to control with RoomView of Crestron Electronics, Inc.
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through "AMX Device Discovery". For details, refer to
the website of AMX Corporation.
URL http://www.amx.com/
Set to [ON] when connecting the "XTP transmitter" of Extron Electronics to the <DIGITAL LINK/LAN>
terminal.
[EXTRON XTP] must be set to [OFF] when connecting the optional digital interface box (Model No.:
ET-YFB100G).
For details of the "XTP transmitter", refer to the website of Extron Electronics.
URL http://www.extron.com/
Save the current network control settings.
Advertisement
Table of Contents
