Completing The Parts Replacement - Lenovo 30CY User Manual

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 108.

Completing the parts replacement

CAUTION:
After replacing a CRU, reinstall all protective covers, including the computer cover, before connecting
power and operating the computer. This action is important to help prevent unexpected electrical
shock and help ensure the containment of an unexpected fire that could happen under extremely rare
conditions.
After completing the installation or replacement for all parts, pivot the drive bay assembly inward, reinstall the
front bezel, reinstall the computer cover, and reconnect cables. Depending on the parts you installed or
replaced, you might need to confirm the updated information in the Setup Utility program. Refer to "Using the
Setup Utility program" on page 33.
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your computer. See "Computer components" on page 5 for the locations of various components
in your computer.
2. Ensure that the cables are routed correctly before reinstalling the computer cover. Keep cables clear of
the hinges and sides of the computer chassis to avoid interference with reinstalling the computer cover.
3. Press the release tab as shown and pivot the drive bay assembly inward until it snaps into position.
Figure 113. Pivoting the drive bay assembly downward
108
P330 User Guide