Table of Contents
Advertisement
When [WPS connection successful.] is displayed, select [Close] and press the
(Enter) button.
• When [Connection failed. Timeout] is displayed, repeat the procedure from step 14.
• [Overlap] is displayed when multiple WPS push buttons are pressed almost at the same time at two or more
wireless LAN access points and connection is not established. Wait for a while, and then try again.
15
If the antenna mark is displayed at the top right of the home screen, the
connection is established correctly.
The antenna mark may not be displayed on some screens.
Selecting a Wireless LAN Access Point from the Operator Panel to Connect
If a wireless LAN access point does not support WPS, you can specify a wireless LAN
access point you want to use from the wireless LAN access points that the machine detects
to establish a connection. In such a case, you must enter an encryption key.
1
Check the SSID and encryption key by referring to the instruction manual that
is included in a wireless LAN access point or other documents, and write the
information down.
WPA-EAP and WPA2-EAP cannot be set on the operator panel. Set them from the Web page of this machine.
Open the Web Page of This Machine (Advanced Manual)
• An SSID is also called a network name, ESSID or ESS-ID.
• An encryption key is also called a network key, security key, password or Pre-shared Key.
2
Check that the wireless LAN access point starts and is operating properly.
3
Turn the machine on.
Check that the screen displays "Do you want to Set-up wireless?" and [Yes] is selected, Press the
button and go to step 6.
4
Press the
button repeatedly to select [Setting] and press the
button.
5
Press the
button repeatedly to select [Wireless(Infrastructure) Setting] and
press the
(Enter) button.
6
Enter the administrator password, and then press the
The factory default administrator password is "999999". If the administrator password is
changed, enter the updated password.
The "It is not possible to use the Wireless(AP Mode) at the same time." message is
displayed for approximately five seconds.
7
Select [Enable] and then press the
8
If your environment requires to set IP address, etc. manually, press the
button to select [Network Setting], and then press the
do not need to set manually, go to step 12.
9
Press the
button to select [Manual] on the [Wireless (infrastructure)
settings] screen, and then press the
10
Follow the onscreen instructions to set the IP address, subnet mask, default
gateway, and DHCP v6.
Ask your provider or network administrator about the setting value.
11
Select [Close] when the Wireless (infrastructure) settings are complete, and
then press the
The screen switches automatically in a while without pressing [Close].
12
Press the
button repeatedly to select [Wireless Network Selection] and
press the
(Enter) button.
The machine starts searching for wireless LAN access points. Wait for a while.
13
Select a wireless LAN access point to connect, and then press the
button.
(Enter)
- 40 -
(Enter) button.
(Enter) button.
(Enter) button.
2. Setting Up
(Enter)
(Enter) button.
(Enter) button. If you
(Enter)
Advertisement
Table of Contents
