Thermos HEATWAVE 461262409 Product Manual page 20

11
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart left
side panel with the nut, shown A.
Insert AA battery into ignition module, negative (
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. otal (4) connections.
T
Connect the two wires[(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
Total (2) connections.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
A
Nut
B
Cap
12
Attach FireBox lower heat shield to the tank heat shield using two #8x3/8" self-tapping screws, shown A.
Inside of cart, insert rear tank heat shield tabs(w/o holes) into slots on the bottom of upper back panel.
Attach front tank heat shield tabs(w/ holes) under front brace using two #8x3/8" self-tapping screws, shown B.
Tank heat shield
(concave faces up)
20
Electronic
ignition module
Heat shield
-
+
AA battery
#8x3/8" self-tapping screw
-
) end first. Then put on the cap, shown B.
A
side view
Tab w/o hole
Front brace
Upper back panel
Tank heat shield
1
(a)
2
3
4
(b)
Tank heat shield
Tab w/ hole
(rear)
(front)
#8x3/8" self-tapping
screw
B