Pedestal Installation - LG STEAM DRYER DLGX5966W User's Manual & Installation Instructions

O P T I O N A L AC C E S S O R I E S

PEDESTAL INSTALLATION

Make sure the side surface of the appliance
3
is clean and dry. Remove paper backing from
the tape on the bracket.
Install 2 screws to securely attach the bracket
5
to the pedestal.
Once properly attached, firmly press the top
part of the bracket with the double-sided
tape to the side of the appliance. Repeat
steps 3–5 to attach the other brackets.
NOTE: If the brackets are not installed
properly, noise and vibration may result. Be
sure to remove paper backing and to use all
screws to install the brackets.
Move the appliance to the desired location.
0
(cont.)
4
6
Position the bracket as shown. The bent part
of the bracket should rest along the edge
of the pedestal, and the holes in the bottom
part of the bracket should align with the
holes in the pedestal.
Raise
Loosen the locknuts on all 4 leveling feet
of the pedestal until you can turn them
with the wrench. Turn clockwise to raise
or counterclockwise to lower. Once the
pedestal is level and all 4 feet are solidly
against the floor, securely tighten all locknuts
by hand.
NOTE: Noise and vibration may result if
locknuts are not tightened.
Be sure to connect the appliances to all
water, power, or gas lines and draining or
venting connections before operation.
If there is excessive vibration during the
first operation after installation, slightly
adjust the leveling feet.
Lower