Table of Contents
Advertisement
cAuTioN
f
SPIDER
ALERT!
If you notice thatyour grill is getting hard to light or thatthe
flame isn't as strong as it should be, take the time to check and
clean the ventud's.
CONTROLPANEL
SPIDERWEBS
INSIDE VENTURI
!
BURNER
In someareasof the country,spidersor small insectshavebeen
knownto create"flashback" p roblems.The spidersspinwebs,build
nestsand layeggs in the grill'sventuritube(s)obstructing the flow of
gasto the burner.Thebacked-upgascan ignitein the venturibehind
thecontrolpanel.This is knownasa flashbackand it candamage
yourgrill and evencauseinjury.
Topreventflashbacksand ensuregoodperformance the burnerand
venturiassemblyshouldbe removed from the grill and cleaned
eforeusewheneverthe grill hasbeen idlefor an extendedperiod, j
J
Storing Your Grill
• Clean cooking grates.
• Store in dry location.
• When LP cylinder is connected to grill, store outdoors in a well-
ventilated space and out of reach of children.
• Cover grill if stored outdoors. Choose from a variety of grill
covers offered by manufacturers.
• Store grill indoors ONLY if LP cylinder is turned off and
disconnected, removed from grill and stored outdoors.
• When removing grill from storage, follow "Cleaning the Burner
Assembly" instructions before starting grill.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1.
Turn gas OFF at control knobs and LP cylinder,
2.
Remove cooking grates and flame tamers.
3.
Remove carryover tubes and burners.
4.
Detach electrode from burner.
NOTE: Removal/Detachment method will depend on the
burner configuration. See different configurations in
illustrations below.
5.
Carefully lift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Run the hook through each burner
tube several times.
r.._.,_
_
(B) Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brush through each
burner tube several times.
(C) Wear eye protection: Use an air hose to force air into
the burner tube and out the burner ports. Check each
port to make sure air comes out each hole.
6.
Wire brush entire outer surface of burner to remove food
residue and dirt.
7.
Clean any blocked ports with a stiff wire such as an open
paper clip.
8.
Check burner for damage, due to normal wear and corrosion
some holes may become enlarged. If any large cracks or
holes are found replace burner.
VERY IMPORTANT:Burner tubes must reengage valve
openings. See illustrations at right.
9. Attach electrode to burner.
Correct
burner-to-valve
10. Carefully replace burners,
engagement
11. Attach burners to brackets on firebox.
12. Reposition carryover tubes and attach
to burners. Replace flame tamers and
cooking grates.
Firebox
burner
bracket
_ii_ ¸
Electrode
I
bracket
;off
electrode with
a flat blade
screwdriver
Advertisement
Table of Contents
