Summary of Contents for Char-Broil 46322354632236 / 0-P47F2A (01-15-02)®4632236
Page 1
- especially 1 - 8 0 0 - 2 4 1 - 7 5 4 8. as noted in the manual! Wear protective gloves Visit us on the web at: if necessary. www.charbroil.com 4632236 / 0-P47F2A (01-15-02) 4632236 • 1...
Installation Safety Precautions WARNING WARNING WARNING WARNING WARNING • This grill is designed for natural gas use at 7 inch water column supply pressure. Verify supply pressure with your local gas company. Not for use with LP gas. FOR YOUR SAFETY •...
Table of Contents Warranty Char-Broil warrants to the original consumer-purchaser that For Your Safety ................. 2 this product shall be free from defects in workmanship and Call Grill Service Center For Help And Parts ......2 materials under normal and reasonable use and correct Installation Safety Precautions ..........
Before Beginning Assembly Parts List - 4632236 • Necessary tools for assembly of your grill include: Description Part # P0197A ® Phillips screwdriver, pliers and adjustable wrench. Heat Indicator P0616A Curved Stainless Steel Handle P0267A Name Plate - Professional Series P0478A Warming Rack P1531B...
4. Screw the 4 casters into the caster seats in the bottom of Assembly - 4632236 each cart leg. Turn the threaded caster stem by hand, clockwise until it stops. Fully tighten with the wrench • Unpack and remove all protective packaging. provided.
Page 7
11. Place the side shelves over the brackets and cross braces To reduce the weight of the grill head, open the grill lid and with the wider-spaced shelf holes to the outside (shelf with remove the packed components. This step requires 2 people trim plate on right side).
Page 8
15. Secure grill head to all cart legs using 4 of the 1/4x2-1/2" 21. Thread the L-shaped fitting on regulator onto the manifold. Phillips-head screws and 1/4" nuts. See Fig. 6. Be sure the regulator is pointing down, then wrench-tighten the connection.
Page 9
23. Place the 3 flame tamers on the lower ledge above 28. Thread the natural gas hose (sold separately) onto the burners. See Fig. 10. They should meet in the center. regulator fitting and wrench-tighten the connection. See Fig. 12. Please read "Connecting Your Grill to the 24.
With proper assembly, plug cannot be removed without Use and Care pushing sleeve back. To disconnect, push sleeve back and pull plug out of sleeve (this automatically shuts off gas). Connecting Your Grill to the Please Note: Hose and assembly are A.G.A. certified and C.G.A. Natural Gas Source listed for natural gas, manufactured gas, mixed gas and for IMPORTANT:...
Page 11
Safety Tips WARNING WARNING WARNING WARNING WARNING When grill is not in use, turn off all control knobs and gas source. Never move grill while in operation or still hot. • Do not use grill until leak checked. When moving the grill push it forward, do not pull from •...
Page 12
Rotisserie Ignitor Lighting UTION UTION CAUTION UTION UTION Do not lean over grill while lighting. 1. Open lid during lighting 2. To ignite rotisserie burner, push in and turn rotisserie knob • Putting out grease fires by closing the lid is not slowly, to ON, allowing gas to reach burner.
Cleaning The Burner Assembly CAUTION UTION UTION UTION UTION Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill. Clean burners prior to use after storing, at the 1. Turn gas off at control knobs and gas source. beginning of grilling season or a period of 2.
Indirect Cooking Food Safety Poultry and large cuts of meat cook slowly to perfection on the • Food safety is a very important part of enjoying the outdoor grill by indirect heat. The heat from selected burners circulates cooking experience. To keep food safe from harmful gently throughout the grill, cooking meat or poultry without the bacteria, follow these four basic steps: touch of a direct flame.
Troubleshooting Problem Possible Cause Prevention/Cure Clean wires and/or electrode with rubbing alcohol and clean swab. Burner will not Wires and/or electrode covered with light using ignitor. cooking residue. Replace electrode(s). Electrode cracked or broken "sparks at crack" Main Burners: Tip of electrode should be pointing toward tip of collector Electrode tip not in proper position box.
Page 16
A Division of W.C. Bradley Co. P. O. Box 1240 Columbus, GA 31902-1240 16 • 4632236...