Kyocera 1102RX3NL0 Operation Manual page 183

Troubleshooting > Troubleshooting
Symptom
Printed images are skewed.
Irregular horizontal lines
appear in the image.
The altitude is 1000 m or
higher and irregular
horizontal white lines appear
in the image.
The altitude is 1000 m or
higher and dots appear in
the image.
Dirt on the top edge or back
of the paper.
Part of the image is
periodically faint or shows
white lines.
Checkpoints
Is the paper loaded correctly?
―
―
―
Is the interior of the machine dirty?
―
―
―
Corrective Actions
Check the position of the paper width
guides.
Select the [Menu] key > [Adjust/Maintenance]
> [Service] > [MC] > [OK] > [OK] and increase
the adjustment value. Increase the adjustment
value 1 level at a time from the current value. If
there is no improvement after the value is
increased by 1 level, increase by 1 level again.
If there is still no improvement, return the
setting to the original value.
Select the [Menu] key > [Adjust/Maintenance]
> [Service] > [Altitude Adj.], and set to an
elevation one level higher than the current
setting.
Select the [Menu] key > [Adjust/Maintenance]
> [Service] > [Altitude Adj.], and set to an
elevation one level higher than the current
setting.
Clean the interior of the machine.
Open and then close the front cover.
Select the [Menu] key > [Adjust/Maintenance]
> [Service] > [Drum] > [OK] > [OK].
Select the [Menu] key > [Adjust/Maintenance]
> [Service] > [MC] > [OK] > [OK] and decrease
the adjustment value. Decrease the adjustment
value 1 level at a time from the current value. If
there is no improvement after the value is
decreased by 1 level, decrease by 1 level
again. If there is still no improvement, return the
setting to the original value.
8-14
Reference
Page
page 3-2
―
―
―
page 8-2
―
―
―