Oki C834 User Manual page 98

Cause
The machine is processing data from Wait until printing is complete.
another interface.
[Receiving data timeout] or [Invalid Press the scroll button
Data] is displayed on the operator the operator panel to select [Menus] >
panel and the machine does not [System Adjust] > [Timeout Injob] and
print. set a longer period of time. The
factory default setting is 40 seconds.
If the job is not printed with "Received
invalid data" displayed, the selected
emulation language may not match
this machine (model). Make sure that
the printer driver you use supports this
model of the machine.
Network Connection Problems
• Common to Windows and Mac
Cause
Using a cross cable. Use a straight cable.
The machine was turned on before a Connect cables before turning the
cable was connected. machine on.
There is a problem with the Press the scroll button
compatibility with the hub. operator panel to select [Admin Setup]
> [Network Setup] > [HUB Link
Setting], and then change the setting.
The network connection setting is To connect to a wired network, set
incorrect. [Wired] for [Network Setup] to
[Enable].
• For Windows
Cause
The IP address is incorrect. • Check that the same IP address is
set for the machine and the
machine's port setting on the
computer.
• Check that the IP address is not
duplicated by another device.
• Check that the correct IP address,
subnet mask, and gateway address
are set.
• If using OKI LPR Utility, check the IP
address setting with OKI LPR Utility.
All pages are not printed. If you are using the WSD port, change
it to the standard TCP/IP port.
Solution Reference
-
or on -
Solution Reference
-
Connecting a LAN Cable
on the -
Connecting a LAN Cable
Solution Reference
Test Printing from the Printer
OKI LPR Utility (Advanced
Manual)
-
Wireless LAN is Not available (Infrastructure)
At Print Network Information and Wireless(Infrastructure) Information, check the following
explanation while checking the items numbered (1) to (6) in the figure below.
To print Network Information, select [Functions] > [Print Information] > [Network].
• Unable to connect to an access point (
"Connected".)
Cause
[Wireless(Infrastructure)] indicates Select [Enable] for
"Disable". [Wireless(Infrustructure)].
* Refer to as shown above. * You cannot enable wireless LAN
(infrastructure) and wireless LAN (AP
mode) at the same time.
[SSID] is incorrect. Or it is blank. Check whether the SSID of the
* Refer to as shown above. desired wireless LAN access point is
correct.
If it is blank, the SSID is not set.
[Security] is incorrect. Check whether to correspond with the
* Refer to as shown above. security (ciphering method) of the
desired wireless LAN access point.
The encryption key is incorrect. Check whether to correspond with the
encryption key of the desired wireless
LAN access point.
The desired wireless LAN access The printer does not support Channel
point is set to Channel 12 or 13. 12 and 13.
Change the channel setting of the
wireless LAN access point.
- 98 -
6. Troubleshooting
indicates the status other than
Solution Reference
Connecting to an Access Point
(Infrastructure)
Connecting to an Access Point
(Infrastructure)
Connecting to an Access Point
(Infrastructure)
Connecting to an Access Point
(Infrastructure)
-