Appendix; Maintenance; Restrictions On Oiling; Precautions On Storing The Machine - Brother XM2701 Operation Manual

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
6 A PPEN DI X

MAINTENANCE

Restrictions on oiling

In order to prevent damaging this machine, it must not
be oiled by the user.
This machine was manufactured with the necessary
amount of oil applied to ensure correct operation,
making periodic oiling unnecessary.
If problems occur, such as difficulty turning the
handwheel or an unusual noise, immediately stop using
the machine, and contact your authorized dealer or the
nearest authorized service center.
Precautions on storing the
machine
Do not store the machine in any of the locations
described below, otherwise damage to the machine
may result, for example, rust caused by condensation.
Exposed to extremely high temperatures
Exposed to extremely low temperatures
Exposed to extreme temperature changes
Exposed to high humidity or steam
Near a flame, heater or air conditioner
Outdoors or exposed to direct sunlight
Exposed to extremely dusty or oily environments
Note
In order to extend the life of this machine,
periodically turn it on and use it.
Storing this machine for an extended period
of time without using it may reduce its
efficiency.

Cleaning

CAUTION
Make sure you unplug the machine
before you clean it, otherwise you risk
getting an electric shock or being
injured.
47
Turn off the machine and unplug it.
1
Raise the needle and the presser foot.
2
Loosen the presser foot screw and the
3
needle clamp screw to remove the presser
foot holder and the needle.
Using the oval screwdriver, remove the
4
two screws. Lift up the needle plate as
shown in the illustration, and then slide
the needle plate to the left to remove it.
Use the oval screwdriver
1
Grasp the bobbin case, and then lift it out
5
to the left.
1