Onkyo TX-SR494DAB Instruction Manual page 79

„ 2. Dolby
Change the setting of when Dolby signals are input.
Setting Item Default Value
Loudness On
Management
Setting Details
When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Late Night function that allows you to
enjoy surround at low volumes is fixed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": When this function is used
"Off": When this function is not used
Contents Connections
≫
„ 3. DTS
Change the setting of when DTS signals are input.
Setting Item Default Value
DTS Auto On
Surround
Dialog Control 0 dB
„ 4. LFE Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series,
Multichannel PCM, and DSD signals.
Setting Item Default Value
LFE Level 0 dB
79
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
When inputting DTS signals that include extended
channel information, the optimum listening mode is
automatically selected according to the extended
information contained in the input signal and the
speaker configuration of this unit when playing in
the straight decoding listening mode.
"On": When this function is used
"Off": Audio is played using the same number
of channels in the input signal according to the
speaker configuration of this unit.
• If this function is set to "Off", the ES Matrix and
ES Discrete listening modes cannot be selected.
You can increase the volume of dialog portion of
the audio up to 6 dB by 1 dB step so that you can
hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not
be selected.
Setting Details
Select the low-frequency effect (LFE) level of each
signal from "0 dB" to "-∞ dB". If the low-frequency
effect sound is too strong, select "-20 dB" or "-∞ dB".
≫