Table of Contents
Advertisement
16
Using the Main Menu
3. Under Event Type, select the hard drive event you would like to configure. Check Enable
to activate the selected warning.
• No HDD: No hard drive detected.
• Disk Error: A hard drive error has been detected.
• Disk Full: The hard drive is full or almost full. You can enter the percentage of disk space
remaining that will trigger a warning under Less Than (e.g. when less than 10% of the
hard drive is empty, trigger a warning). Disk Full warnings will not occur if overwrite is
enabled.
• All: Configure warnings for all hard drive events.
4. Configure the responses the system will take when the selected event occurs:
• Alarm Out: Check the box to activate alarm output devices (not included) when the se-
lected event occurs. Select the alarm output devices that will be activated, then enter the
number of seconds the alarm output device(s) will activate after the selected event occurs
next to Latch.
• Show Message: Show a popup message on the monitor.
• Send Email: Check to enable email alerts. You must configure email alerts before you
will be able to receive them (see 16.4.4 Configuring Email Alerts, page 68).
• Buzzer: Check to activate the system buzzer.
5. Click Apply to save changes.
16.4.10 Configuring Network Warnings
Network warnings will notify you if there your system loses connection to the Internet or local
network or if there is an issue on your network.
To configure network warnings:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click
, then click EVENT. Click the WARNING tab on the side panel, then click
the Network tab on the top panel.
3. Under Event Type, select the event type you would like to configure. Check Enable to acti-
vate the selected warning.
• Disconnect: The system has lost connection to the network.
• IP Conflict: More than one device on your network has the same IP address.
• MAC Conflict: More than one device on your network has the same MAC address.
• All: Configure responses for all network events.
#LX400117; r. 6.0/57895/57895; en-US
75
Advertisement
Table of Contents
