Table of Contents
Advertisement
Cleanup
Use only oil-based (non-flammable) or
water-based materials, or non-flammable
paint thinners. Do not use materials having
flash points below 100°F (38°C).
Do not use materials which state
"FLAMMABLE" on the packaging. For
more information about your material,
request SDS from distributor or retailer.
Clean in a well-ventilated area. Keep a
good supply of fresh air moving through the
area.
To avoid serious injury or damage to
equipment, do not expose the sprayer
electronics to cleaning fluids. Keep sprayer
at least 10 in. (25 cm) above the rim of the
container when cleaning.
Cleaning Sprayer
Cleaning your sprayer properly and after every
spray job is of the utmost importance! Proper
care and maintenance will make your paint
sprayer last and work for you trouble free. See
Cleaning Fluid Compatibility, page 26 and
Static Grounding Instructions (Oil-Based
materials), page 26 for additional information
when using oil-based materials.
1.
Turn Prime Pump/Spray knob to Prime
Pump to relieve pressure.
2.
Open the VacuValve to allow air into the
FlexLiner.
3.
Separate the cup support with FlexLiner
from the cup cover/sprayer.
3A4476E
ti29756a
4.
Set the sprayer upside down on a flat
surface. This will keep the wet paint in
the cup cover. Return excess material to
original container. Hold the FlexLiner in
place when pouring.
ti29759a
Cleanup
17
Advertisement
Table of Contents
