Turning The Machine On; Turning The Machine Off; Setting Water Hardness; Setting Temperature - DeLonghi ECAM35025SB Manual

4. TURNING THE MACHINE ON

Please note:
Before turning the machine on, make sure the main switch (A6)
on the back of the machine is pressed (fig. 1).
Each time the machine is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The ma-
chine is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
(A19) and is collected in the drip tray (A15) underneath. Avoid
contact with splashes of water.
• To turn the machine on, press the
7). The light (B1) flashes on the touch screen (B) to in-
dicate the machine is heating up.
While heating up, the machine performs a rinse cycle. As well
as heating the boiler, this also heats the internal circuits by cir-
culating hot water.
The machine is at temperature when the
screen goes off and the coffee icons come on.

5. TURNING THE MACHINE OFF

Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts
(A19). Avoid contact with splashes of water.
• To turn the machine off, press the
7);
• the light (B1) flashes on the touch screen and (if pro-
vided for) the machine performs a rinse cycle then goes off
(standby).
Please note:
If you will not be using the machine for some time, unplug from
the mains socket:
• first turn the machine off by pressing the
• release the main switch (A6) (fig. 1).
Important!
Never press the main switch while the machine is on.

6. SETTING WATER HARDNESS

For instructions on setting water hardness, see section "19. Set-
ting water hardness".

7. SETTING TEMPERATURE

If you want to modify the temperature of the water used to
make the coffee (low, medium, high, maximum), proceed as
follows:
1. With the machine off (standby), but the main switch
2. Press and hold the
3. Press the
4. Press the
button (A24) (fig.
light on the touch
5. Press the
The machine returns to "standby" and the temperature is now
programmed.
button (A24 - fig.

8. AUTO-OFF

The time can be changed so that the machine switches off after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
To change the Auto-off setting, proceed as follows:
1. With the machine off (standby), but the main switch
2. Press and hold the
button;
3. Press the
4. Select the required time interval by pressing the
10
pressed on (A6) (fig. 1);
icon (B9) until the lights on the
touch screen (B) come on;
icon (B10);
icon again to select the required
temperature:
low
medium
high
maximum
OK icon (B15) to confirm (or
(B14) to exit without making the change).
The lights go off.
pressed on (A6) (fig. 1);
icon (B9) until the icons on the
touch screen (B) come on;
icon (B11);
again:
ESC
icon
15 min.
30 min.
1 hour