LG 60PZ570T Owner's Manual page 154

154
EXTERNAL CONTROL DEVICE SETUP
25. 3D (Command: x t) (only 3D models)
► To change 3D mode for TV.
Transmission [x][t][ ][Set ID][ ][Data01][ ][Data02]
[ ][Data03][ ][Data04][Cr]
Data01 00 : 3D On
01 : 3D Off
02 : 3D to 2D
03 : 2D to 3D
Data02 00 : Top and Bottom
01 : Side by Side
02 : Check Board
03 : Frame Sequential
Data03 00 : Right to Left
01 : Left to Right
Data04 3D Depth : Min: 0 to Max: 14
* Refer to 'Real data mapping'. (See p.153)
* If data1 is 00(3D On), data4 has no meaning.
* If data1 is 01(3D off) or 02(3D to 2D), data2, data3 and
data4 have no meaning.
* If data1 is 03(2D to 3D), data2 and data3 have no
meaning.
Data1 Data2 Data3
00 O O
01 X X
02 X X
03 X X
X : don't care
Ack [t][ ][OK][Data01][Data02][Data03][Data04][x]
[t][ ][NG][Data01][x]
Data4
X
X
X
O
26. Extended 3D (Command: x v) (only 3D models)
► To change 3D option for TV.
Transmission [x][v][ ][Set ID][ ][Data01][ ]
[Data02][Cr]
Data01 : 3D option
00 : 3D Picture Correction
01 : 3D Depth (2D to 3D Only)
02 : 3D Viewpoint
03 : 3D Picture Size (Only Plasma TV)
04 : 3D Picture Balance (Only Plasma TV)
05 : 3D Optimization (Only LED LCD TV / LCD TV)
Data02 It has own range for each 3D option determined by
Data01.
1) When Data01 is 00
00 : Right to Left
01 : Left to Right
2) When Data01 is 01
Data Min: 0 to Max: 14
3) When Data01 is 02
Data Min: 0 to Max: 14
Data value range(0 to 20) converts Viewpoint range(-10 to
10) automatically.
4) When Data01 is 03 (Only Plasma TV)
00 : Just Scan
01 : 16:9
5) When Data01 is 04 (Only Plasma TV)
00 : Off
01 : On
6) When Data01 is 05 (Only LED LCD TV / LCD TV)
Data Min: 0 to Max: 02
* Refer to 'Real data mapping'. (See p.153)
Ack [v][ ][OK][Data01][Data02][x][v][ ][NG]
[Data01][x]
* Use the feature depending on your model.