Grizzly G0768Z Manual page 64

12. Remove 20T gear with keyed bushing from
80T gear (see Figure 80).
Keyed Bushing
20T Gear
Figure 80. 20T gear removed from 80T gear.
13. Remove keyed bushing from 20T gear.
14. Connect 80T and 60T gear with keyed bush-
ing, as shown in Figure 81. The 80T gear
hub faces out; the 60T gear hub faces the
80T gear.
Bushing
60T Gear
Front View
80T Gear
Figure 81. 80T and 60T gears connected.
15. Put dab of NLGI #2 grease onto 80T/60T
gear shaft, then insert longer end of shaft into
gear (see Figure 82).
Figure 82. Shaft installed into 80T/60T gears.
-54-
80T Gear
Hub
Rear View
Shaft
16. Thread short end of 80T/60 gear shaft into
T-nut on adjuster until finger tight (see Figure
83).
Figure 83. 80T/60T gear threaded onto T-nut.
17. Remove 30T gear with keyed bushing from
84T gear.
18. Install 30T gear with keyed bushing onto 53T
gear (see Figure 84). Hub of 53T gear should
face 30T gear.
30T Gear
53T Gear
Figure 84. 53T/30T gears assembled.
19. Put a dab of grease on upper shaft, then slide
53T/30T gear on, as shown in Figure 85.
53T/30T Gear
Figure 85. 53T/30T gear installed on upper
shaft.
Model G0768/G0769 (Mfd. Since 8/15)
T-Nut
Keyed
Bushing