Related Manuals for LG V290H
Summary of Contents for LG V290H
- Page 1 DVD PLAYER/ VIDEO CASSETTE RECORDER OWNER’S MANUAL MODEL : V290H Before connecting, operating or adjusting this product, please read this instruction booklet carefully and completely.
-
Page 2: Safety Precautions
EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC. CAUTION: European representative: LG Electronics Service Europe B.V. This Digital Video Disc Player employs a Laser System. Veluwezoom 15, 1327 AE Almere, The To ensure proper use of this product, please read this Netherlands owner’s manual carefully and retain for future reference,... -
Page 3: Table Of Contents
Table of Contents Introduction Operation Safety Precautions......2 Operation with tape ..... . 21-25 Table of Contents. -
Page 4: Before Use
Before Use To ensure proper use of this product, please read this Notes on Discs owner’s manual carefully and retain for future reference. Handling Discs This manual provides information on the operation and Do not touch the playback side of the disc. Hold the maintenance of your DVD player. -
Page 5: Types Of Playable Discs
Before Use (Continued) Notes on Copyrights: Types of Playable Discs It is forbidden by law to copy, broadcast, show, broad- cast via cable, play in public, or rent copyrighted materi- al without permission. This product features the copy (8 cm / 12 cm disc) protection function developed by Macrovision. -
Page 6: Front Panel
Front Panel 9 10 11 12 14 15 8. DVD/VCR 1. 1 1 / / I Switches the unit to ON or OFF. DVD/VCR Selecto 2. Disc Tray 9. x x Insert a disc here. Stops playback. 10. . . / / m 3. -
Page 7: Remote Control
Remote Control POWER TV Control Buttons (see p. 35) Switch this unit ON or OFF. TV POWER: Turns on or off the TV. DVD/VCR select button TV AV: Selects the TV’s source. Selects operational mode of TV PR +/–: Selects TV’s channel. remote control. -
Page 8: Rear Panel
Rear Panel AERIAL Connect the aerial using this jack. VIDEO/AUDIO OUT(Left/Right) (DVD/VCR OUT) Connect to a TV with video and audio inputs. COMPONENT/PROGRESSIVE SCAN VIDEO OUT (Y Pb Pr) (DVD EXCLUSIVE OUT) Connect to a TV with Y Pb Pr inputs. AUDIO OUT (Left/Right) (DVD EXCLUSIVE OUT) Connect to an amplifier, receiver or stereo system. -
Page 9: Connections
Connections Caution: S-Video connection Make sure this unit is connected directly to the TV. 1. Connect the S-VIDEO OUT jack on this unit to the Set the TV to the correct video input channel. S-Video input jack on the TV using the S-Video Do not connect this unit’s AUDIO OUT jack to the cable (S). -
Page 10: Resolution Setting
Connections (Continued) Resolution setting Warning: Due to the DTS Licensing agreement, the digital output The resolution setting support only DVD playback. will be in DTS digital out when DTS audio stream is selected. 1. Before you set the resolution, this unit must be in stop mode. -
Page 11: Hdmi Connection
HDMI Connection If you have a HDMI TV or monitor, you can connect it to this DVD+VCR using a HDMI cable. HDMI compatible TV HDMI 1. Set the TV’s source to HDMI (refer to TV’s Owner’s manual). 2. Connect the HDMI OUT jack on the unit to the HDMI jack on a HDMI compatible TV or monitor (H). -
Page 12: Before Operation-Vcr Part
Before Operation-VCR part Tuning in a video channel on your Using your VCR for the very first time Video channel (RF output channel) is the channel on Following picture will display on the TV screen when which your TV receives picture and sound signals from you have just connected your video recorder for the the DVD+VCR through the RF cable. -
Page 13: Setting The Clock Manually
Before Operation-VCR part Setting the clock Manually To set the colour system The clock in your DVD+VCR controls time and date set- 1. Press i. tings for your DVD+VCR. 2. The main menu will appear on the TV screen. The clock is set automatically during ACMS (Automatic Channel Memory System) when your DVD+VCR 3. -
Page 14: How To Use The Main Menu
Before Operation-VCR part How to use the main menu Tuning in TV Stations Automatically This DVD+VCR can easily be programmed by using the If the TV broadcast signal is weak your DVD+VCR may menus displayed on screen. not detect the necessary information and will not be able The menus are controlled by the Remote Control to store them correctly. -
Page 15: Tuning In Tv Stations Manually
Before Operation-VCR part Tuning in TV Stations Manually In certain areas of the country broadcast signals may STATION be too weak for your DVD+VCR’s automatic tuning process to find or assign TV stations correctly. You must tune in these weaker broadcast stations man- CHANNEL/CABLE : AV P SET ually in order for your DVD+VCR to store them. -
Page 16: Changing The Order Of Tv Stations
Before Operation-VCR part Changing the order of TV Stations Deleting TV Stations After tuning TV stations into your DVD+VCR you may After tuning TV stations into your DVD+VCR you may wish to change the order in which they are stored wish to delete a station. -
Page 17: Before Operation-Dvd Part
Before Operation-DVD part Displaying Disc Information Initial Settings on-screen By using the DVD Setup menu, you can make various You can display various information about the disc adjustments to items such as picture and sound. You loaded on-screen. can also set a language for the subtitles and the Setup menu, among other things. -
Page 18: Language
Before Operation-DVD part LANGUAGE DISPLAY DISPLAY LANGUAGE TV Aspect 16 : 9 English Menu Language Display Mode Widescreen Disc Audio Original TV Output Select Disc Subtitle Disc Menu Original Move Select Move Select TV Aspect Menu Language Select a language for the VCR and DVD’s setup menu 4:3 : Select when a standard 4:3 TV is connected. -
Page 19: Audio
Before Operation-DVD part AUDIO LOCK (Parental Control) Each DVD disc has a variety of audio output options. LOCK Set this unit’s AUDIO options according to the type of Rating Unlock audio system you use. Password Area Code AUDIO Dolby Digital Bitstream Bitstream MPEG... -
Page 20: Area Code
Before Operation - DVD part DivX(R) VOD Area Code We provide you the DivX ® VOD (Video On Demand) Enter the Area Code whose standards were used to registration code that allows you to rent and purchase rate the DVD video disc, based on the list in the videos using the DivX ®... -
Page 21: Operation With Tape
Operation with tape Playing a tape , Shuttle : 5. Slow motion playback During playing back or still picture press You will only be able to load and eject video cassettes You can reach the following playback speeds. when your DVD+VCR is plugged into the mains. (REV, PB 5-, PB 1-, Still, SLW, PLAY, 2PLY, CUE) Your DVD+VCR may also playback recordings from To switch off the slow motion and shuttle, press the... -
Page 22: Instant Timer Recording (Itr)
Operation with tape Instant Timer Recording (ITR) 7. Press PAUSE/STEP to avoid recording unwanted scenes. Press PAUSE/STEP to continue recording. Your DVD+VCR allows you to make recordings using a variety of simple methods: Tapes can be paused for up to 5 minutes; RECP will be displayed when a tape is paused. -
Page 23: Programiranje Showview
Operation with tape Programming 6. Press to select the recording speed. ShowView greatly simplifies entering the date, channel, Press to select the desired tape speed (SP, start and end times of a Timer Recording by simply IP, or LP). entering a ShowView Code. ShowView Codes are pub- IP mode determines how much tape is left and lished in most TV guide magazines;... -
Page 24: Timer Recording Using On Screen Display
Operation with tape Timer recording using On Screen Display You may set up to seven timer record events within one month of the current date. Note: 6. Use v/V/1/2 buttons to enter the recording start and Before setting the timer make sure that you have set the end times of the programme that you wish to record. - Page 25 Operation with tape To watch a DVD while performing a timer recording, Timer recording using On Screen press DVD to select DVD mode. Display (Continued) 8. Press i to set another timer record event and follow steps 3 to 7. Check that the timer event details are correct.
-
Page 26: Additional Operation - Vcr Part
Additional Operation - VCR part Hi-Fi Stereo Sound System Tape Counter Memory Stop This allows you to record and playback the sound in The Digital Tape Counter can be displayed on the dis- several different ways. Video cassettes recorded on play window instead of the time by pressing CLK/CNT your DVD+VCR will have a normal mono audio track on the remote control. -
Page 27: Video Doctor (Self-Diagnosis)
Additional Operation - VCR part Video Doctor (Self-Diagnosis) Wide Screen Compatibility 16:9 This feature informs you that there is a problem with your Your DVD+VCR can record and play back wide screen DVD+VCR. These error messages will appear on the TV aspect ratio programmes (16:9). -
Page 28: Recording From External Components
Additional Operation - VCR part Recording from External Components Copying from DVD to VCR You can record from an external component, such as a You can copy the contents of a DVD to a Video tape. camcorder or VCR, connected to any of the 1. -
Page 29: General Playback Features - Dvd Part
General Playback features - DVD Part Buttons Operations Discs Z (OPEN / CLOSE) Opens or closes the disc tray. X (PAUSE) During playback, press X to pause playback. Press X repeatedly to play Frame-by-Frame. DivX . / > During playback, press . or > to go to the next chap- ter/track or to return to the beginning of the current chapter/track. -
Page 30: Playing A Dvd
Playing a DVD Notes on general features: Marker Search DivX • If you press > once during Repeat Chapter (Track) To enter a Marker playback, the repeat playback cancels. You can start playback from up to nine memorized • Zoom may not work on some DVDs. points. -
Page 31: Playing An Audio Cd Or Mp3/Wma File
Playing an Audio CD or MP3/WMA file This unit can play Audio CDs or MP3/WMA files record- Programmed Playback ed media. The program function enables you to store your favorite MP3/ WMA/ Audio CD tracks from any disc in the player memory. Once you insert an MP3/WMA files recorded media or A program can contain 30 tracks. -
Page 32: Viewing A Jpeg File
Viewing a JPEG file This unit can play JPEG files recorded media. Moving to another File 1. Insert a JPEG files recorded media. The PHOTO Press . or > or cursor (b or B) once while menu appears on the TV screen. viewing a picture to advance to the next or previous file. -
Page 33: Playing A Divx Movie File
Playing a DivX Movie file Using this DVD Player you can play DivX file. DivX disc compatibility with this player is limited as follows: 1. Insert a DivX file recorded media. The MOVIE menu • Available resolution size of the DivX file is under appears on the TV screen. -
Page 34: Playing A Dvd Vr Format Disc
Playing a DVD VR format Disc This unit will play DVD-R/RW discs recorded using the DVD-Video format that have been finalized using a DVD-recorder. • This unit will play DVD-RW discs recorded using the Video Recording (VR) format. 1. Insert a disc and close the tray. The DVD-VR menu appears on the TV screen. -
Page 35: Additional Operation
Refer to the information in this chapter before contacting a service technician. You can control the sound level, input source, and power switch of your LG TV with the supplied remote Handling the Unit control. You can control the sound level, input source, and When shipping the unit power switch of non-LG TVs as well. -
Page 36: Language And Area Code List
Language and Area Code List Language Code List Use this list to input your desired language for the following initial settings: Disc Audio, Disc Subtitle, Disc Menu. Language Code Language Code Language Code Language Code Abkhazian 6566 Fiji 7074 Lingala 7678 Singhalese 8373... -
Page 37: Troubleshooting
Troubleshooting Check the following guide for the possible cause of a problem before contacting service. Symptom Cause Correction No power. The power cord is disconnected. Plug the power cord into the wall outlet securely. The power is on, but No disc is inserted. Insert a disc. -
Page 38: Specification
Specification General Power requirements AC 200-240V, 50/60 Hz Power consumption Dimensions (approx.) 430 x 78.5 x 265 mm (W x H x D) Mass (approx.) 4.2 kg Operating temperature 5˚C to 35˚C (41˚F to 95˚F) Operating humidity 5 % to 90 % Timer 24 hours display type RF Modulator...