Table of Contents
Advertisement
Getting Ready
1.
Attach side panels
Secure the side panels using four
• When installing parts
slots in either end of crosspiece
are not inserted into the ends of the crosspiece as
far as they will go, the screws
enter into the screw holes of the brackets
can strip the threads of the screws.
• Cover the screw heads with the caps
I
A
E
2
1
2.
Use the two screws
and right edges of the back panel
brackets
of side panels
IMPORTANT!
• Make sure that the back panel is positioned
correctly as described below when installing it.
– Before sliding back panel into place, make sure
that the widely spaced screw holes along the
bottom of the panel are on the left (when viewed
from the front of the stand), and the narrowly
spaced holes are on the right.
Wide
C
EN-32
and
to crosspiece
screws.
, slide the brackets
into the
. If the brackets
will not be able to
, which
.
D
I
E
to secure the top left
to the
and
.
Narrow
.
• At location
before installing the screw.
4
J
G
3.
Next, secure the bottom of the back panel
with the six screws
B
4.
Adjust the height adjustment screw
provide support so crosspiece
bow downwards when the pedals are
pressed.
D
IMPORTANT!
• Pressing the pedals without adjusting height
adjustment screw can result in damage to
crosspiece . Always make sure you adjust height
adjustment screw before operating the pedals.
, slip the clip
onto to the screw
3
G
.
B
C
F
5
A
to
does not
Advertisement
Table of Contents
