Plugging In The Power Cord And Grounding; Test Run - LG WM3650H A Series Owner's Manual

machine gently to make sure that the
washing machine does not rock. If the
washing machine rocks, level the washing
machine again.
Plugging in the power cord and
grounding
Make sure to ground the washing machine to
prevent a short circuit or an electric shock when
plugging in.
Using a 3-prong outlet
Plug in the electrical outlet without additional
grounding.
WARNING
y The power outlet must be within 60 inches (1.5 m)
of either side of the washer.
y The appliance and outlet must be positioned so that
the plug is easily accessible.
y Do not overload the outlet with more than one
appliance.
y The outlet must be grounded in accordance with
current wiring codes and regulations.
y Time-delay fuse or circuit breaker is
recommended.
y It is the personal responsibility and obligation
of the product owner to have a proper outlet
installed by a qualified electrician.
y Do not use a worn or damaged power cord or
power plug. Replace or repair it immediately.
Failure to do so may result in death, fire, electric
shock, or malfunction.
y Do not modify the power cord and take care not to
damage it when installing or moving the washing
machine. Failure to do so may result in death, fire,
electric shock, or malfunction.
y Make sure that the washing machine is grounded.
y Connect this washing machine to a grounded outlet
conforming to the rating prior to use. Failure
to do so may result in fire, electric shock, or
malfunction.
y Do not use adaptors or extension cords. The
washing machine should always be plugged
into its own individual electrical outlet which has
a voltage rating that matches the rating plate.
Failure to do so may result in fire, electric shock
or disorder.
y Do not damage or cut off the ground prong of the
power cord. Doing so may cause death, fire,
electric shock, or product malfunction.
INSTALLATION INSTRUCTIONS

Test run

Check if the washing machine is properly
installed and run a test cycle.
1
Load the washing machine with 6 pounds of
laundry.
B
2 A
Press and turn
3
Press to RINSE + SPIN.
4 C
Press .
- The wash cycle starts.
5
Check if water is supplied, that the washing
machine does not rock or vibrates excessively,
and that it drains well during the spin cycle.
- If water leaks during water supply, see page
14, Connecting the water lines to connect them
properly.
- If the washing machine rocks and vibrates
excessively, see page 16, Leveling the washing
machine to level it again.
- If the drain does not work, see page 15,
Connecting the drain line to install it properly.
17
on the right