Table of Contents
Advertisement
STEP 3:
PREPARE THE VENTING BLOWER
Your microwave oven is shipped with the blower assembled for roof venting. You need to adjust the blower if
you want wall-venting or room-vented (recirculating) installation.
G
DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring
could result in electrical shock.
Remove two screws that attach mounting plate to
microwave oven cabinet. See Figure 10.
Remove mounting plate and set aside. Replace the screws.
ROOF-VENTED INSTALLATION:
1. Insert one side of exhaust adaptor and attach with
the one tapping screw on the other side of exhaust
adaptor to the blower plate.
Go to STEP 4 on page 12.
WALL-VENTED INSTALLATION:
1. Remove one blower unit mounting screw and two blower
plate screws. Remove the blower plate from cabinet.
See Figure 12.
2. Carefully lift the blower unit out of the microwave oven.
3. Use side cutters or tin snips to cut and remove knockouts
parts "B" from Back plate. Discard knockouts.
Be careful not to distort the plate. See Figure 13.
4. Rotate the unit so that the exhaust ports face the rear of
the cabinet. See Figure 14. When you insert blower unit,
blower wire must be like figure 14.
5. Place blower unit back into cabinet. Check that the
exhaust ports face towards the rear of the cabinet.
See Figure 15.
6. Reattach the blower plate to cabinet so the
exhaust ports and blower plate opening are aligned.
Attach with one blower unit mounting screw and
then two blower plate mounting screws.
See Figure 16.
back Plate
Parts "B"
Figure 13
W A R N I N G
ELECTRICAL SHOCK HAZARD!
UNPLUG UNIT BEFORE WORKING ON IT.
See Figure 11.
Knockouts Parts "B"
Control panel side
Mounting plate screws
Damper
blower unit
mounting screw
blower unit
Parts "B"
— 10 —
Mounting plate
Figure 10
Tapping screw
(Bright color)
Exhaust
adaptor
back plate
Figure 11
blower plate
mounting screw
blower plate
back plate
Figure 12
blower
unit
exhaust
ports
Figure 14
Advertisement
Table of Contents
