LG LMV-1620DW Installation Instructions Manual page 14

STEP 5: INSTALL THE MOUNTING
PLATE TO THE WALL
THE OVEN MUST BE CONNECTED
TO AT LEAST ONE WALL STUD.
1. Draw a vertical line on the wall at the center of the
30" wide space.
Use the mounting plate as the template for the
rear wall. Place the mounting plate on the wall,
making sure that the tabs are against the bottom
of the cabinet. Line up the notch and center line
on the mounting plate to the center line on the
wall.
2. While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C and D.
Four holes must be used for mounting. If the holes
are not used, the installation will not be secure.
Installer must use these holes for proper
installation. Use toggle bolts through these holes
unless one of them lines up with a stud. Use a
wood screw for studs.
NOTE: Draw a fifth circle inside area E, through
one of the bottom holes to match the location of a
stud.
For wall-vented: The oven requires a rear wall cutout
opening for the rear wall duct and the exhaust
adaptor must be attached to the mounting plate. See
the next page on how to prepare the rear wall cutout
opening and the exhaust adaptor/mounting plate for
wall-vented.
3. Drill holes on the circles. If there is a stud, drill a 3
/ 16" hole for lag screws. If there is no stud, drill a
3 / 4" hole for toggle bolts. Make sure to use at
least 1 lag screw in a stud, and 4 toggle bolts in
the drywall or the plaster.
4. Attach the plate to the wall. To use spring toggle
heads bolts: Remove the toggle wings from the
bolts. Insert the bolts into the mounting plate and
replace the spring toggle heads to 3 / 4" past the
bolt ends. Insert the spring toggle heads into the
holes in the wall to mount the bracket. You may
pull forward on the bracket to help in tightening
the toggle bolts. Tighten all bolts.
"
Minimum 66
From the Floor
Mounting
Plate
A
C
Center Line
Support Tab
Mounting
Plate
— 14 —
3/16" Hole on Studs
3/4" Hole on Drywall Only
For Wall-
Vented Only
Draw Lines
on Studs
Draw
Center Line
E
Support Tab
Figure 26
Space More Than Wall Thickness
Toggle Wings
Toggle Bolt
Wall
Figure 27
B
D
Bolt
End