Table of Contents
Advertisement
STEP 3: Prepare The Venting Blower
Your microwave oven is shipped with the blower assembled for room-vented. You need to adjust the blower if you
want wall-vented or roof-vented installation.
ELECTRICAL SHOCK HAZARD! UNPLUG UNIT BEFORE WORKING ON IT.
• DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could result in
electrical shock.
1. Remove any shipping materials and parts from inside the
microwave oven. Set them aside for later use.
2. Cover the counter top or cooktop with a thick, protective
covering to protect it from damage and dirt. See Figure 11.
NOTE: If you have a free-standing range, disconnect
it, move it onto a piece of cardboard or hardboard and
pull it away from the wall, so that you can get closer to
the upper cabinet and back wall for easier measuring
and drilling.
3. Locate exhaust adaptor, grease filters and hardware packet.
4. At this point, remove any adhesive tape (if there is any), on the
exhaust adaptor, the grease filters and the power supply cord.
ROOM-VENTED INSTALLATION:
This oven is shipped assembled for room-vented. You need to
go to STEP 4: PREPARE THE WALL & UPPER CABINET located
on page 13 .
• When changing the vent fan position for rear wall vent or roof vent:
1. Properly align the ventilation fan openings and blower plate knockouts.
2. Ventilation fan openings should be completely exposed to the outside.
3. After installation, check the air ventilation path. Refer to page 8 Figures 6-8 for proper vent selection.
Wrong installation can cause problems such as:
•
1. Inability to assembly blower plate or ventilation motor correctly.
2. Abnormal noise during product operation.
3. Weak ventilation.
4. Product overheating - possibility of product breakdown or fire.
w
W A R N I N G
w
W A R N I N G
- 9 -
A thick, protective
covering
Figure 11
.
Advertisement
Table of Contents
