Light (Led); Tips For Saving Energy - Siemens KG39FPI30 Instructions For Use Manual

Removing the container
Fig. -
Pull out the container all the way and lift
to detach it.
To insert the container, place on
the telescopic rails and push into
the appliance. Attach the container by
pressing it down.
Taking out the humidity filter
Fig. !/16
The humidity filter over the humidity
container can be taken out for cleaning.
To do this, first take out the humidity
container and pull out the humidity filter.
Lift off the filter cover, Fig. ., and take
out the filter. Clean in lukewarm water,
leave to dry and re-assemble.
Taking out the frozen food container
Fig. $
Pull out the frozen food container all
the way, lift at the front and remove.
General information for looking
after the surfaces
Clean surfaces with luke warm water
and a little washing-up liquid. After
cleaning, rub thoroughly dry.

Light (LED)

Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.

Tips for saving energy

Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
To avoid increased power
■
consumption, occasionally clean the
back of the appliance.
If available:
■
Fit wall spacers to obtain the indicated
energy rating of the appliance (see
Installation instructions). A reduced
wall gap will not restrict the function
of the appliance. The energy rating
may then increase slightly. The gap
of 75 mm must not be exceeded.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.
en
39