English
22
Warning icons and error codes
Meaning of the warning icons
Fill the water tank with fresh
water to the MAX level
indication.
ADD WATER
The bean hopper is empty.
Put new coffee beans in the
bean hopper.
ADD COFFEE
The brew group is not in the
machine or it is not inserted
properly. Insert the brew
group.
Insert the drip tray.
Meaning of the error codes
What to do if the descaling procedure is interrupted
Once the descaling procedure has started, you must let the machine
perform the entire procedure until the very end without switching off the
machine. If the machine gets stuck during descaling, you can exit the
descaling procedure by pressing the standby button. If this occurs, or in case
of a power failure or accidental disconnection of the cord, do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank up to the CALC CLEAN level indication and switch the
machine back on. The machine will heat up and perform an automatic
rinsing cycle.
3 Before brewing any beverages, perform a manual rinsing cycle.
Note: If the descaling procedure was not completed, the machine will
require another descaling procedure as soon as possible.
Warning icons are displayed in red. Below you find a list of the warning
icons that may appear on the display and their meaning.
Below you find a list of the error codes that may appear on the display, their
meaning and how to solve the problem. If these solutions do not help to
remove the error code from the display and bring the machine back to
Close the service door.
Remove the coffee grounds
container and empty it.
If the display shows an error
10
code, check section ' Meaning
of the error codes' to see what
the code on the display means
xx
and what you can do. The
machine cannot be used when
this icon is on the display.