What To Do If The Descaling Procedure Is Interrupted; Warning Icons And Error Codes; Meaning Of The Warning Icons - Philips EP4050 User Manual

English
22

Warning icons and error codes

Meaning of the warning icons

Fill the water tank with fresh
water to the MAX level
indication.
ADD WATER
The bean hopper is empty.
Put new coffee beans in the
bean hopper.
ADD COFFEE
The brew group is not in the
machine or it is not inserted
correctly. Insert the brew
group.
The coffee grounds container
is full. Make sure the machine
is switched on. Then remove
and empty the coffee
grounds container.
15 Clean the brew group by performing the 'Weekly brew group cleaning'
cycle.
16 Install a new AquaClean filter in the water tank.
Tip: Using the AquaClean filter reduces the need for descaling!

What to do if the descaling procedure is interrupted

If the machine gets stuck during descaling, you can exit the descaling
procedure by pressing the standby button. If this occurs, or in case of a
power failure or accidental disconnection of the cord, do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank with fresh water up to the CALC CLEAN level indication
and switch the machine back on. The machine will heat up and perform
an automatic rinsing cycle.
3 Before brewing any beverages, perform a manual rinsing cycle. To
peform a manual rinsing cycle, first dispense half a water tank of hot
water (see 'Dispensing hot water') and then brew 2 cups of pre-ground
coffee without adding ground coffee (see 'Brewing coffee with pre-
ground coffee').
Note: If the descaling procedure was not completed, the machine will
require another descaling procedure as soon as possible.
The brew group is blocked by
coffee powder. Clean the brew
group.
Insert the drip tray and close
the service door.
The CoffeeSwitch is in the
wrong position for the selected
beverage. Push the lever down
to the ESPRESSO position.
The CoffeeSwitch is in the
wrong position for the selected
beverage. Push the lever up to
the COFFEE position.