Setting Option Setup Method - Samsung AC035JNMCEH Service Manual

4-2 Setting Option Setup Method

In order to set the indoor unit option code use the wired remote controller and follow the directions below.
Main Menu Sub-menu
1) Press the and
displayed.
2) Press the / button to select
3) Press the / button to select
screen.
• The first digit represents the page number and the remaining five digits are option codes.
• The option code which is currently setting will flicker.
NOTE
4) Press the / button to set the option code in order. Press
5) Press the button to save and complete the option setting.
6) Press the button to exit to normal mode.
• Press the button anytime during setup to exit without setting.
NOTE
• Option code will not be applied if you don't press the
• Setting indoor unit option code is only possible in Master wired remote controller.
You can only check the indoor unit option code in Slave wired remote controller.
• Setting indoor unit option code is possible when one indoor unit is connected. If more than 2
indoor units are connected, you can only check the Master indoor unit option code.
4-4
Data bit
1 2 3 4 5 6
buttons at the same time for more than 3 seconds and then a Main menu will be
and then press
and then press
Page number Option Code
1 2 3 4 5 6
SEG1 SEG2 SEG3
0
 
Page number
SEG7 SEG8 SEG9
1
 
Page number
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
 
Page number
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
 
Page number
button to enter a Sub-menu setting screen.
button to enter a Indoor unit option code setting
button to go to the next page.
SEG4 SEG5 SEG6
  
SEG10 SEG11 SEG12
  
  
  
Samsung Electronics