5-11 Sata Drive Connections - Supero A+ 1012A-MRF User Manual

Power LED
DS1 is an Onboard Power LED. When this
LED is lit, it means power is present on the
serverboard. Be sure to turn off the system
and unplug the power cord(s) before remov-
ing or installing components.
IPMI LED
The serverboard contains an IPMI LED
(DP1) located near the corner above the
PCI-E slots. When this LED is lit, it means a
connection is active for the built-in IPMI on
the serverboard.
Note: This LED is not installed on non-IPMI
boards.

5-11 SATA Drive Connections

SATA Ports
There are no jumpers to configure the SATA
ports, which are designated SATA0 through
SATA5. See the table on the right for pin
definitions.
Chapter 5: Advanced Motherboard Setup
State
On
Off
State
On
Off
Pin # Definition
1
2
3
4
5
6
7
5-21
Power LED
(DS1)
System Status
Standby power present
on motherboard
No power connected
IPMI LED (DP1)
System Status
Active connection
No connection
SATA Ports
Pin Definitions
(SATA0-SATA5)
Ground
TXP
TXN
Ground
RXN
RXP
Ground