Table of Contents
Advertisement
SUPERSERVER AS-4021GA-62R+F User's Manual
5-11 Floppy, IDE, SAS and SATA Drive Connections
Use the following information to connect the IDE hard disk drive cables.
•
A red mark on a wire typically designates the location of pin 1.
•
The 80-wire ATA100/66 IDE hard disk drive cable that came with your system
has two connectors to support two drives. This special cable should be used
to take advantage of the speed this new technology offers. The blue connector
connects to the onboard IDE connector interface and the other connector(s) to
your hard drive(s). Consult the documentation that came with your disk drive for
details on actual jumper locations and settings for the hard disk drive.
IDE Connectors
There are two IDE connectors (one blue
and one white) on the serverboard. IDE#1
(blue) is designated as the Primary IDE
drive. The white connector is designated as
the Secondary IDE drive and is reserved
for Compact Flash Card use only. (See the
note below.) See the table on the right for
pin defi nitions.
Note: The white slot is reserved for Com-
pact Flash Cards only. Do not use it for
other devices. If populated with a Compact
Flash Card, IDE#1 (the blue slot) will be
available for one device only. For the Com-
pact Flash Card to work properly, you will
fi rst need to enable with JCF1 and connect
a power cable to JWF1.
IDE Drive Connector
Pin Defi nitions (IDE#1)
Pin#
Defi nition
1
Reset IDE
3
Host Data 7
5
Host Data 6
7
Host Data 5
9
Host Data 4
11
Host Data 3
13
Host Data 2
15
Host Data 1
17
Host Data 0
19
Ground
21
DRQ3
23
I/O Write
25
I/O Read
27
IOCHRDY
29
DACK3
31
IRQ14
33
Addr1
35
Addr0
37
Chip Select 0
39
Activity
5-30
Pin #
Defi nition
2
Ground
4
Host Data 8
6
Host Data 9
8
Host Data 10
10
Host Data 11
12
Host Data 12
14
Host Data 13
16
Host Data 14
18
Host Data 15
20
Key
22
Ground
24
Ground
26
Ground
28
BALE
30
Ground
32
IOCS16
34
Ground
36
Addr2
38
Chip Select 1
40
Ground
Advertisement
Table of Contents
