Mitsubishi XD8000 User Manual page 13

Setting up your projector (continued)
Setting the projector posture
You can select the posture of the projector. Set
COOLING CONDITION in the INSTALLATION 1 menu
according to the posture.
Important:
• Inconsistency between the projector posture and
the menu settings may cause breakdown or failure
of the projector or the lamp.
• When you use the projector in the HIGH ALTITUDE
mode, the selectable projector posture is floor
installation (0°) and ceiling installation (180°) only.
Setting the projection angle
• Set COOLING CONDITION in the INSTALLATION
1 menu referring to the figure below. The default
setting is 0°.
Projection angle setting
Angle range
135°
135˚ ± 30˚
180°
180˚ ± 15˚
Ceiling installation
225°
225˚ ± 30˚
(See page 32 for menu setting.)
1. Display the INSTALLATION 1 menu.
2. Select COOLING CONDITION by pressing the  or
 button.
COOLING CONDITION
3. Press the ENTER button.
COOLING CONDITION
COOLING CONDITION
4. Select the angle by pressing the  or  button.
5. Press the ENTER button.
Important:
• If the setting value selected in the menu is
inconsistent with the actual projection angle, the
cooling condition setting dialog appears. In this
case, select the projection angle using the  or 
button and then press the ENTER button.
Straight up
90°
90˚ ± 15˚
45°
45˚ ± 30˚
0˚ ± 15˚
Floor installation
315°
315˚ ± 30˚
270°
270˚ ± 15˚
Straight down
0°
0°
Setting HIGH ALTITUDE MODE
• Set HIGH ALTITUDE MODE in the INSTALLATION
1 menu according to the altitude at which you use
the projector. The default setting is STANDARD.
• Select STANDARD when using the projector at an
altitude from 0 to 2000 meters.
• Select HIGH ALTITUDE when using the projector at
an altitude from 2000 to 2700 meters.
Important:
• If you select STANDARD when using the projector
at an altitude higher than 2000 meters, the
projector may break down or fail.
• When you use the projector in the HIGH ALTITUDE
mode, only floor installation and ceiling installation
are allowed.
(See page 32 for menu setting.)
1. Display the INSTALLATION 1 menu.
2. Select HIGH ALTITUDE MODE by pressing the 
or  button.
3. Press the ENTER button.
0°
4. Select STANDARD
pressing the  or  button.
5. Press the ENTER button.
Setting IMAGE REVERSE
• Set IMAGE REVERSE in the INSTALLATION 1 menu
according to the orientation of the projector. The
default setting is OFF.
• Select OFF for the combination of floor installation
and front projection.
• Select MIRROR INVERT for the combination of
ceiling installation and front projection.
• Select MIRROR for the combination of floor
installation and rear projection.
• Select INVERT for the combination of ceiling
installation and rear projection.
(See page 32 for menu setting.)
1. Display the INSTALLATION 1 menu.
2. Select IMAGE REVERSE by pressing the  or 
button.
3. Select OFF, MIRROR, INVERT or MIRROR INVERT
by pressing the  or  button.
EN-13
HIGH ALTITUDE MODE
HIGH ALTITUDE MODE
HIGH ALTITUDE MODE
or HIGH ALTITUDE
IMAGE REVERSE
STANDARD
STANDARD
by
OFF