Hifonics Thor Series Owner's Manual page 27

FUNCTIONAL INSTRUCTIONS
If the test was performed successfully 4 checkmarks in the check boxes appear. Then press
[OK] Click here to start to continue.
Should one of the checkmarks not appear, a problem occurred that can lead to a malfunction.
Please refer to the information in the Trouble Shooting section.
The configuration screen will appear next. Here you can determine how many RCA audio inputs
you want to assign to the DSP unit and how these signals should be routed to speaker outputs.
Select under Create New Setting:
- YES to create a new setting.
Confirm the message Reset all Settings with OK.
- NO to keep the existing setting.
Under Delay Unit you can select the unit of time delay. Choose between centimeters [cm] or
milliseconds [ms].
Channel Matrix
Under INPUT MODE you can configure the input channels of the amplifier according to the
RCA audio inputs you've connected.
Please make a choice:
- 2CH, 4CH or 6CH according to the RCA cables you are using
- Mix. This function generates a sum signal of the LINE IN and
SUB IN RCA audio inputs
Under OUTPUT MODE you can assign the inputs to the corresponding outputs.
With 1, 2 or 3 (only available with INPUT MODE 4CH and 6CH) you can choose a suitable
configuration.
Then click OK to continue.
27