Zero Feeding - Janome 502X Servicing Manual

ZERO FEEDING

ADJUSTMENT PROCEDURE:
1. SET THE PATTERN SELECTOR DIAL AT "
2. PLACE A PIECE OF PAPER ON THE NEEDLE PLATE. TURN THE HANDWHEEL TOWARD YOU SLOWLY
BY HAND AND CHECK THE MOVEMENT OF A PAPER.
3. IF THE PAPER MOVES FORWARD, REMOVE THE CAP AND TURN THE ADJUSTING SCREW IN
DIRECTION (A).
IF THE PAPER MOVES BACKWARD, TURN THE ADJUSTING SCREW IN DIRECTION OF (B).
ADJUSTING SCREW
MECHANICAL ADJUSTMENT
www.promelectroavtomat.ru
", AND THE STITCH LENGTH DIAL AT " 0 ".
(A)
(B)
CAP
21