Stretch Stitch Balance - Janome 502X Servicing Manual

STRETCH STITCH BALANCE

ADJUSTMENT PROCESURE:
1. SET THE PATTERN SELECTOR DIAL AT "
DIAL AT "S1".
2. SET THE FEED ADJUSTING KNOB AT "
3. PLACE A PIECE OF PAPER ON THE NEEDLE PLATE.
4. LOWER THE PRESSER FOOT AND TURN THE HANDWHEEL TOWARD YOU TO CHECK THE
FORWARD AND BACKWARD NEEDLE DROP POSITIONS.
5. REMOVE THE CAP AS SHOWN BELOW.
IF THE REVERSE STITCH LENGTH (B) IS SHORTER THAN THE FORWARD STITCH LENGTH (A),
TURN THE ADJUSTING SETSCREW IN THE DIRECTION OF (C). IF THE REVERSE STITCH LENGTH
(B) IS LONGER THAN THE FORWAERD STITCH LENGTH (A), TURN THE ADJUSTING SETSCREW
IN THE DIRECTION OF (D).
www.promelectroavtomat.ru
MECHANICAL ADJUSTMENT
", ZIGZAG WIDTH DIAL AT "0", AND STITCH LENGTH
".
ADJUSTING SCREW
14
CAP