Zero Feeding - Janome HD718 Service Manual

ZERO FEEDING

TO CHECK:
1. Set the stitch selector to
2. Place a piece of paper on the needle plate.
3. Check if the paper moves FORWARD OR BACKWARD when you turn the handwheel toward
you.
4. The machine should not feed a piece of paper at this setting.
ADJUSTMENT PROCEDURE:
1. Remove the belt cover. (See page 6)
2. Set the stitch selector at
3. Place a piece of paper on the needle plate.
4. If the paper moves forward, turn adjusting screw (C) in the direction (A).
If the paper moves backward, turn adjusting screw (C) in the direction (B).
MECHANICAL ADJUSTMENT
and the stitch length dial to "0".
and the stitch length dial at " 0 ".
(A)
(B)
(C)
FORWARD
BACKWARD
23