Jumper Settings; Setting Jumpers - Acer Aspire M1610 Service Manual

Jumper Settings

This section explains how to set jumpers for correct configuration of the mainboard.

Setting Jumpers

Use the motherboard jumpers to set system configuration options. Jumpers with more than one pin are
numbered. When setting the jumpers, ensure that the jumper caps are placed on the correct pins.
System Board Jumper Setting
On-board Jumper and
default setting (See Pin
definition for the detail)
System Board Header Setting
Front Panel
Illustration
Silk Screen
FP1
62
Features
CLR_CMOS(PIN2_3)1
& default setting
Pin Signal Name
1 5V_SYS
2 GPIO_GRN_HDR_R Pull-up(330 ohm) to 5V_SB_SYS and connect to
3 HDD_LED_R
4 GPIO_YLW_HDR_R Pull-up(330 ohm) to 5V_SB_SYS and connect to
5 GND
6 PSIN
7 ICH_SYS_RSTJ
8 GND
9 5V_SYS
10 KEY
11 NC
12 5V_SB
13 NC
14 LAN_ACTJ
Footprint
h2x7mzo10h85
Default setting
2-3 : Normal (Default) 1-2 : Clear CMOS
Hard disk LED pull-up(330 ohm) to 5V_SYS
SIO GPIO
Hard disk active LED
SIO GPIO
Reset button
Power Button
ICH_SYS_RSTJ
Ground
5V_SYS
Key
Reserved. Do not use
LAN LED pull-up(330 ohm) to 5V_SB
Reserved. Do not use
Lan active LED
Schematic Part
HEADER_2X7_10
Remark (color and
other)
2-3 : Normal (Default)
Description
Chapter 5