Table of Contents
Advertisement
Specifications
AMPLIFIER SECTION
Power output (at 230 V for Continental Europe)
(at 240 V for the United Kingdom)
DIN 1 kHz (T.H.D. 1 %)
40 Hz–20 kHz continuous power output
both channels driven
Total harmonic distortion
rated power at 40 Hz–20 kHz
half power at 1 kHz
Power output at 1 kHz each channel driven
DIN 1 kHz (T.H.D. 1 %)
Front
Center
Surround
Power bandwidth
both channels driven, –3 dB
Damping factor
Load impedance
Front
[SA-DX850] A or B
[SA-DX850]
A and B
[SA-DX750]
Center
Surround
Frequency response
[SA-DX850 only] PHONO
CD, TAPE/MD, DVD, TV, VCR
Input sensitivity and impeadance
[SA-DX850 only] PHONO
CD, TAPE/MD, DVD, TV, VCR
S/N at rated power (6 Ω)
[SA-DX850 only] PHONO
CD, TAPE/MD, DVD, TV, VCR
Tone controls
BASS
TREBLE
Output voltage
TAPE/MD REC (OUT), VCR OUT
Channel balance (250 Hz–6.3 kHz)
Channel separation
Headphones output level and impeadance
Subwoofer frequency response (–6 dB)
Digital input
Optical
Coaxicial
30
RQT5818
(DIN 45 500)
2 x 80 W (6 Ω)
2 x 60 W (6 Ω)
2 x 80 W (6 Ω)
2 x 80 W (6 Ω)
10 Hz–40 kHz (6 Ω)
RIAA standard curve (30 Hz–15 kHz) ±0.8 dB
10 Hz–40 kHz, ±3 dB
200 mV/22 kΩ
70 dB (IHF, A: 80 dB)
75 dB (IHF, A: 85 dB)
50 Hz, +10 to –10 dB
20 kHz, +10 to –10 dB
430 mV/330 Ω
FM TUNER SECTION
Frequency range
Sensitivity
S/N 30 dB
S/N 26 dB
S/N 20 dB
IHF usable sensitivity (IHF'58)
0.9 % (6 Ω)
IHF 46 dB stereo quieting sensitivity
0.07 % (6 Ω)
Total harmonic distortion
MONO
STEREO
S/N
80 W (6 Ω)
MONO
STEREO
Frequency response
20 Hz–15 kHz
30 (6 Ω)
Alternate channel selectivity
±400 kHz
Capture ratio
4–16 Ω
Image rejection at 98 MHz
8–16 Ω
IF rejection at 98 MHz
6–16 Ω
Spurious response rejection at 98 MHz
6–16 Ω
AM suppression
6–16 Ω
Stereo separation
1 kHz
Carrier leak
19 kHz
38 kHz
Channel balance (250 Hz–6.3 kHz)
3 mV/47 kΩ
Limiting point
Bandwidth
IF amplifier
FM demodulator
Antenna terminal
AM TUNER SECTION
Frequency range
200 mV
Sensitivity
±1 dB
Selectivity (at 999 kHz)
55 dB
IF rejection (at 1000 kHz)
7–200 Hz
VIDEO SECTION
Output voltage at 1 V input (unbalanced)
Maximum input voltage
2
Input/output impedance
1
GENERAL
Power supply
For Continental Europe
For the United Kingdom
Power consumption
Dimensions (W x H x D)
Mass
Power consumption in standby mode:
Notes:
1. Specifications are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum
analyzer.
87.50–108.00 MHz
1.5 µV/75 Ω
1.3 µV/75 Ω
1.2 µV/75 Ω
1.5 µV/75 Ω
22 µV/75 Ω
0.2 %
0.3 %
60 dB (73 dB, IHF)
58 dB (67 dB, IHF)
+1 dB, –2 dB
65 dB
1.5 dB
40 dB
70 dB
70 dB
50 dB
40 dB
–30 dB (–35 dB, IHF)
–50 dB (–55 dB, IHF)
±1.5 dB
1.2 µV
180 kHz
1000 kHz
75 Ω (unbalanced)
522–1611 kHz (9 kHz steps)
530–1620 kHz (10 kHz steps)
20 µV, 330 µV/m
55 dB
50 dB
1±0.1 Vp-p
1.5 Vp-p
75 Ω (unbalanced)
AC 230 V, 50 Hz
AC 230–240 V, 50 Hz
220 W
430 x 158 x 375 mm
9.3 kg
2 W
Advertisement
Table of Contents
