The Radio; Manual Tuning - Technics SA-DX850 Operating Instructions Manual

A
2
1
INPUT SELECTOR
2
BAND
EON
3
TUNING
PTY SELECTOR
B
22
RQT5818
DSP
3
SOUND MODE
FM MODE, PTY SEARCH
TUNED
STEREO
TV VCR DVD
MD TUNER/BAND TAPE CD
1
DIRECT TUNING/
1 2 3
DISC
2
≥10/-/--
4 5 6
3
7 8 9 0
TOP MENU MENU
ENTER
DISPLAY RETURN
/ /
– +
DELAY LEVEL
SUBWOOFER SOUND MODE SFC TEST
– +
TV/AV TV VOL MUTING
– +
VOLUME

The radio

1

Manual tuning

A
You can tune radio stations manually by selecting the station's
frequency, or you can preset up to 30 stations into channels to
make tuning simpler ( \ page 23).
1
Turn [INPUT SELECTOR] to select
"TUNER".
2
Press [BAND, EON] to select "FM" or
"AM".
3
Press [TUNING, PTY SELECTOR,
2 , 1] to select the frequency of the
station.
"TUNED" lights when tuned.
"STEREO" lights during FM stereo broadcasts.
Automatic tuning
Hold down [TUNING, PTY SELECTOR, 2, 1] until the frequency
begins to scroll. Tuning stops when a station is found. (Tuning may
stop if there is interference.)
Improving reception
¡FM mode
You can improve FM reception by switching reception to
monaural.
MHz
Press [FM MODE, PTY SEARCH].
"MONO" lights.
Press the button again to cancel.
¡DSP DEFEAT
You can improve reception by turning off the DSP (a page 16).
Press and hold [DSP SOUND MODE] until "DEFEAT" appears.
Press and hold [DSP SOUND MODE] again to turn the DSP on.
MHz
¡For your reference
DVD players can interfere with radio reception. Turn the DVD
player off or move it further away from the antennas if this occurs.
To change the AM frequency step
Press and hold [BAND, EON] for about 3 seconds when AM band is
selected. (The frequency step changes from 9 kHz to 10 kHz.)
To return to the previous step, press and hold [BAND, EON] for
about 3 seconds again.
B Direct tuning
q q Press [TUNER/BAND].
The band changes each time you press the button.
w w Press [DIRECT TUNING/DISC].
e e Press the numbered buttons to enter the
frequency.
e.g. To select 107.90 MHz, press [1] / [0] / [7] / [9] / [0]
Note
1. If you do not press a button while the cursor is flashing, the
display returns to the frequency being received.
2. If the frequency has not been input correctly, "ERROR" will be
displayed.