Table of Contents
Advertisement
3.2 Menu Setting Table
This section describes the details on how to set each item.
NOTE
• The previous screen appears when Exit is selected on each menu.
• Settings marked with an asterisk (*) show that they are default or factory
settings.
SETUP menu
When the password input screen appears, press the Up ( ) and Enter ( ) buttons
in the following sequence:
SETUP screen will appear. (Refer to 3.1.2 for "Menu operation examples".)
Sub Menu
Media
Sensors
alle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 30
,
,
Menu items
Options
Print Power
Standard*
High Power
Low Power
Print Darkness
Contrast
–4 to 4 (0 is default.)
Tear/Peel Position Supply Position
–80 to 80 (0 is default.)
Up/Down Image
Print Position
Shift
0 to 28 (0 is default.)
Left/Right Image
Margin Adjust
Shift
–80 to 80 (0 is default.)
Sensor Select
Label Gap*
Black Mark Lower
Black Mark Upper
Continuous (Off)
Sensor Calibrate Label Gap*
Black Mark Lower
Black Mark Upper
Peeler
V10 CONSUMIBLES S.L.
,
,
. If a password is entered correctly, the
Description
Set stock type here. Standard mode
supports tag, label, or receipt and
High Power mode supports liner-
less and synthetic. If ink is blurred
when you select Standard, select Low
Power instead.
The print contrast can be adjusted.
This Menu sets how much paper is to
be fed during printing.
This Menu will allow adjustment to
the printing position from the current
position by using Up/Down.
This Menu will allow adjustment to
the printing position from the current
position by using Left/Right.
This Menu sets the sensor according
to presently loaded paper stock (Gap,
Black Mark).
For details, refer to Setting the Sensor
Mode on page 54.
Note: Our supplies usually have a
black mark on the back (non-printing
side), so select Black Mark Upper.
This Menu sets sensor leve value for
each sensor (Gap, Black Mark).
Note: For details, refer to Setting the
Stock Sensor on page 56.
46
Advertisement
Table of Contents
