Table of Contents
Advertisement
9. Do not step on the projector or place any objects upon it. Besides probable physical damage
to the projector, doing so may result in accidents and possible injury.
10. Do not place liquids near or on the projector. Liquids spilled into the projector may cause it to
fail. If the projector does become wet, disconnect it from the power supply's wall socket and
call BenQ to have the projector serviced.
Do not remove
Notice on laser
This symbol indicates that there is a potential hazard of eye exposure to
laser radiation unless the instructions are closely followed.
Laser class
(for USA) This Laser Product is designated as Class 3R during all procedures of
operation and complies with IEC/EN 60825-1:2007.
(for WW) This Laser Product is designated as Class 1 during all procedures of
operation and complies with IEC/EN 60825-1:2014.
LASER LIGHT - AVOID DIRECT EYE EXPOSURE.
Do not point laser or allow laser light to be directed or reflected toward other
people or reflective objects.
Direct or scattered light can be hazardous to eyes and skin.
There is a potential hazard of eye exposure to laser radiation if the included
instructions are not followed.
Caution – use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
Laser parameters
Wavelength
Mode of operation
Pulse width
Pulse repetition rate
Maximum laser energy
Total internal power
Apparent source size
Divergence
This equipment has a three-pin grounding-type power plug. Do not
remove the grounding pin. As a safety feature, this plug will only fit a
grounding-type power outlet. If you are unable to fit the plug into the
outlet, contact an electrician.
449nm - 461nm (Blue)
Pulsed, due to frame rate
1.34ms
120Hz
0.698mJ
>100w
>10mm, at lens stop
>100 mili Radian
7
Advertisement
Table of Contents
