M.2 Solid-State Drive Bracket; Optical Drive Cage - Lenovo ThinkStation P350 User Manual

Notes:
• Remove the film that covers the thermal pad (if any) when installing the M.2 solid-state drive and the
heat sink.
• Install the M.2 solid-state drive PCIe adapter in the appropriate PCIe card slot on the system board.
See "PCI-Express card" on page 51.

M.2 solid-state drive bracket

Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, remove these parts in order, if any:
• "Computer cover" on page 42.
• 2.5-inch primary storage drive cage. See "Primary storage drives" on page 46.
• M.2 solid-state drive and heat sink on the system board. See "M.2 solid-state drive and heat sink" on
page 55.
Replacement procedure

Optical drive cage

Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove these parts in order, if any:
• "Computer cover" on page 42
• "Prerequisite" on page 43
• "Front bezel" on page 45
2. Disconnect the signal cable and power cable from the secondary storage drives under the optical drive
cage.
60
P350 User Guide