Cabinet Installation - Goldstar R1801H Service Manual

3.6 CABINET INSTALLATION

1. Open the window. Mark a line on the center of the window
stool between the side window stop moldings.
Loosely attach the sill bracket to the support bracket using
the carriage bolt and the lock nut.
2. Attach the sill bracket to the window sill using the screws
(Type B).
Carefully place the cabinet on the window stool and align the
center mark on the bottom front with the center line marked
window stool.
3. Using the M-screw and the lock nut, attach the support
bracket to the cabinet track hole. Use the first track hole
after the sill bracket on the outer edge of the window sill.
Tighten the carriage bolt and the lock nut. Be sure the
cabinet slants outward.
CAUTION: Do not drill a hole in the bottom pan. The unit is
designed to operate with approximately 1/2" of
water in bottom pan.
4. Pull the bottom window sash down behind the Top retainer
bar until they meet.
NOTE: 1. Do not pull the window sash down so tightly that the
movement of Frame curtain is restricted. Attach the
cabinet to the window stool by driving the screws
(Type B) through the cabinet into window stool.
2. The cabinet should be installed with a very slight tilt
downward toward the outside.
Sill
Bracket
Carriage
Bolt
(M-Screw)
Figure 24
Cabinet
Track hole
Support
Bracket
Carriage bolt
and lock nut
Figure 25
Top
retainer
bar
Figure 26
Figure 27
Figure 28
—21—
Support
Bracket
Lock nut
Machine screw (Type D)
and lock nut
Outer edge
of window
sill
Screw(Type B)
Sill bracket