Air Handling Parts; Cover (At The Top); Blower - Goldstar R1801H Service Manual

2.2 AIR HANDLING PARTS

2.2.1 COVER (AT THE TOP)

1. Remove the front grille. (Refer to section 2.1.1)
2. Remove the cabinet. (Refer to section 2.1.2)
3. Remove 11 screws which fasten the brace and
covers.
4. Remove the covers and the brace. (See Fig. 4)
5. Re-install the components by referring to the
removal procedure, above.

2.2.2 BLOWER

1. Remove the cover. (Refer to section 2.2.1)
2. Remove the 3 screws which fasten the
evaporator at the left side and the top side.
(See Fig. 4)
3. Move the evaporator sideward carefully.
4. Remove the 2 terminals carefully
(See Fig. 5, Electric Heater Model only)
5. Remove the 3 screws which fasten the Heater
Cover.
(See Fig. 5, Electric Heater Model only)
6. Remove the Heater Cover.
(See Fig. 5, Electric Heater Model only)
7. Remove the orifice from the air guide carefully.
(See Fig. 6, Except Electric Heater Model)
8. Remove the clamp which secures the blower with
plier. (See Fig. 6)
9. Remove the blower with plier or your hand
without touching blades. (See Fig. 7)
10. Re-install the components by referring to the
removal procedure, above.
Figure 4
Figure 5
Figure 6
Figure 7
—11—