Whirlpool W10607408B Manual page 6

FOR SERVICE TECHNICIAN'S USE ONLY
Display
014 Drain pump and
recirc. pump
for 25–30 seconds
015 Pause
016 Agitate for
5 seconds
017 Low speed spin
for 5 seconds
018 Spin for
20–30 seconds
019 Agitate for
10 seconds
020 Unlock lid
On models without recirculation pump, only the drain pump will turn on in step 14.
†
Service Diagnostics Pass/Fail Indication
After the cycle completes, the Pass or Failure
status of each step in Service Diagnostics is
available by the following procedures:
Models without a cycle selection knob
Press the soil level or temp buttons. The
sequence step increments using the soil level
button and decrements using the temp button.
Models with a cycle selection knob
In addition to pressing the soil level or temp
buttons, rotating the cycle selection knob
clockwise increments through the cycle
functions while rotating counterclockwise
decrements through the available options.
On all models, the display will flash between
the sequence function number and "PAS"
for Pass, "FAL" for Fail, or "---" if the machine
control is not capable of determining if a
function passed or failed; each will be
displayed for 1 second.
PAGE 6
Service Diagnostics Chart (cont.)
Washer
Function
If water is not being drained or
on recirculated, use service test load
†
control to test the drain pump.
See page 4.
N/A
Use service test load control to manually
test the motor. See page 4.
Use service test load control to manually
test the motor. See page 4.
Use service test load control to manually 30–40
test the motor. See page 4.
Use service test load control to manually
test the motor. See page 4.
If lid does not unlock, use service test
load control to manually test the lid lock.
See page 4.
Total time in minutes
Recommended
Procedure
Exiting Service Diagnostics Mode
Press the POWER button. All loads will be
turned off and the washer will enter standby.
Fault Detection During
Service Diagnostics Execution
Some faults will stop the cycle execution
(see Fault And Error Codes charts on pages
8–10 for those faults [marked with ‡] that
stop the washer). If a fault is detected, the
washer will stop executing the cycle and the
step during which the fault was encountered
will remain on the display. If no action is
taken within 5–10 minutes, the display will
be cleared and the washer will enter
standby mode.
DO NOT REMOVE OR DESTROY
Est. Time
In Seconds
<10
5
5
5
10
5
Appx. 3–4 mins.