Lubrication - Scag Power Equipment CHEETAH II Operator's Manual

Section 7
MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)
HOURS
BREAK-IN
8
(FIRST 10)

7.2 LUBRICATION

GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)
LOCATION
1 Caster Wheel Pivot *
2 Caster Wheel Bearings
3 LOW / HIGH Speed Actuator
4 Cutter Deck Bellcranks
5 Cutter Deck Pusharms
6 Cutter Deck Spindle
+ Compatible Greases:
PROCEDURE: Remove grease cap, part number 484195. Remove plug, part number 482028-01, and
*
install grease zerk. Apply grease to the fitting until new grease appears at the top of the caster extension.
Remove the grease zerk and reinstall the plug. Reinstall the grease cap. Special tool, part number 47007, is
recommended for use in the installation of the grease cap.
40 100 200 500
X
X
X
X
X
X
X
X
LUBRICATION INTERVAL
500 Hours/Yearly
100 Hours/Monthly
200 Hours/Monthly
100 Hours/Bi-Weekly
100 Hours/Bi-Weekly
40 Hours/Weekly
Scag Premium Chassis Grease p/n 486257
Scag Premium Spindle Grease p/n 486258
PROCEDURE
Apply grease to fittings
Check hardware for tightness
Change engine oil filter
Check hydraulic oil level
Replace engine fuel filter
Drain hydraulic system and
replace hydraulic oil
Replace hydraulic oil filter
Adjust electric PTO clutch
Chassis Grease
Chassis Grease
Chassis Grease
Chassis Grease
Chassis Grease
Spindle Grease
35
COMMENTS
See paragraph 7.2
See paragraph 7.4
See paragraph 7.3
See paragraph 7.5
Use SAE 20W50 Motor Oil.
See paragraph 7.3
See paragraph 7.3
See paragraph 6.10
LUBRICANT
R
NO. OF
PLACES
2
2
2
4
2
3