Table of Contents
Advertisement
Fasten onto a wall
1. Peel off the drill template sticker, and stick it onto the wall in a desired location.
2. Use the template to mark and drill the pilot holes.
3. Insert the anchors into the holes.
4. Snap off the plastic cover over the LEDs on the front to reveal the long screw holes.
5. Insert the long screws through the device from front to back.
6. Insert the long screws into the anchors on the wall and tighten.
7. Replace the cosmetic cover over the LEDs on the front. Refer to the illustrations on the
next page.
FortiExtender-311F&312F-QuickStart.indd 17
FortiExtender-311F&312F-QuickStart.indd 17
17
6/1/2021 4:22:40 PM
6/1/2021 4:22:40 PM
Advertisement
Table of Contents
