Table of Contents
Advertisement
SW MODE screen (continued)
Display
Item
mode
(Camera)
USER1 SW
(PB)
(Camera)
USER2 SW
(PB)
(Camera)
USER3 SW
(PB)
(Camera)
WFM
(Camera)
S/S SW INH
(Camera)
FACE
FRAMING
Sets the function assigned to the USER1 button.
INH:
No function is assigned
REC CHECK:
Performs recording check.
FACE DETECT:
This is the face detection function. Performs the AUTO IRIS /
AUTO FOCUS operation centering around the detected face.
Enabled when both focus control and iris control are set to
auto.
IN RED:
Displays the edges in red. (Only for LCD/EVF) During
operation, the LCD/EVF borders are displayed in red.
EXPAND:
The center of the screen is enlarged. (Only for LCD) The
screen border of the LCD monitor turns blue in enlarged view.
CAPTURE:
Records still images. Does not operate during movie recording
and when the PRE REC function is in use.
ATW:
Switches the ATW function ON or OFF.
ATW LOCK:
Fixes the white balance value when the button is pressed
during ATW. Press again to perform ATW.
SHOT MARK:
Shot mark recording. (Page 13) Takes effect during recording,
thumbnail display, and clip display.
INDEX:
Index recording (Page 13) Takes effect during recording.
LAST CLIP:
Deletes the last recorded clip. (Page 13)
• After recording, clips cannot be deleted by switching to PB or PC mode, by
changing the recording format, or by turning off the camera.
BACKLIGHT:
Auto iris control for the backlight compensation.
SPOTLIGHT:
Switches auto iris control ON or OFF for the spotlight.
BLACKFADE: Blackfade (Page 11)
WHITEFADE: Whitefade (Page 11)
Assign a function to the USER2 button.
The setting contents are the same as USER1.
ATW LOCK
Assign a function to the USER3 button.
The setting contents are the same as USER1.
REC CHECK
Switches the waveform display that appears when the WFM button is pressed.
WAVE:
Displays as a waveform.
VECTOR:
Displays as a vector.
WAVE/VECTOR: Each time the button is pressed, the setting changes in the
following order: OFF → WAVE → VECTOR → OFF.
1:
Disables the START/STOP1 SW.
2:
Disables the START/STOP2 SW.
NO: Does not disable any switch. Use to prevent erroneous operation of the
unnecessary START/STOP SW.
Frames the faces detected during operation of the FACE DETECT function with
the USER SW.
The maximum number of detected frames is 15, and faces bigger and closer to
the center of the screen are given priority.
OFF:
Frames are not displayed.
PRIMARY:
Only the high-priority frames are displayed.
ALL:
Cannot be set when you are using INTERVAL REC.
Description of settings
indicates the factory setting.
55
Advertisement
Table of Contents
