Troubleshooting - Ryobi RA-NB1664-S Operator's Manual

PROBLEM
Air leak near the top of the tool or
in the trigger area.
Air leak near the bottom of the
tool.
Tool does nothing or operates
sluggishly.
Tool jams frequently.

TROUBLESHOOTING

CAUSE
Loose screws.
Worn or damaged O-rings or seals.
Loose screws.
Worn or damaged O-rings or seals.
Inadequate air supply.
Inadequate lubrication.
Worn or damaged O-rings or bumper.
Incorrect fasteners.
Damaged fasteners.
Loose magazine.
Dirty magazine.
Worn or damaged driver.
10
POSSIBLE SOLUTION
Tighten screws.
Install overhaul kit.
Tighten screws.
Install overhaul kit.
Verify adequate air supply.
Lubricate tool.
Install overhaul kit.
Verify that fasteners are the correct
size.
Replace fasteners.
Tighten screws.
Clean magazine.
Install driver maintenance kit.